Large-scale Bio-based Additive Manufacturing Archives - Page 3 of 4 - Advanced Structures & Composites Center

Article by Bhandari and Lopez-Anido presenting numerical model to minimize risk in large-format additive manufacturing published in “Progress in Additive Manufacturing “

Article by Bhandari and Lopez-Anido presenting numerical model to minimize risk in large-format additive manufacturing published in “Progress in Additive Manufacturing “ Orono, Maine — An article by ASCC researchers Sunil Bhandari and Roberto A. Lopez-Anido was published in Progress in Additive Manufacturing. The paper, titled, “Coupled thermo-mechanical numerical model to minimize risk in large-format additive […]

Lopez-Anido Featured as Keynote Speaker at XXVII JAIE Conference on Structural Engineering

Lopez-Anido Featured as Keynote Speaker at XXVII JAIE Conference on Structural Engineering October 4, 2022 Orono, Maine — Dr. Roberto Lopez-Anido, Malcolm G. Long Professor of Civil & Environmental Engineering and Advanced Structures and Composites Center (ASCC) research lead at the University of Maine, was featured as a keynote speaker at the 27th Argentine Conference […]

ASCC welcomes undergraduate student researcher as full-time hire to support bio-based housing initiative

ASCC Updates ASCC welcomes undergraduate student researcher as full-time hire to support bio-based housing initiative ORONO, Maine ? The Advanced Structures and Composites Center (ASCC) is pleased to announce the recent hire of Claire Liedtka as an engineer working with the Hub & Spoke Program, a partnership between Oak Ridge National Laboratory (ORNL) and the […]

UMaine-led FOR/Maine coalition chosen as finalist for up to $100 million in EDA’s Build Back Better Regional Challenge

Robert F. Bukaty / AP

Floating offshore wind turbines could bring new power to Maine

Robert F. Bukaty / AP

Maine submits application for nation’s first floating offshore wind farm

Robert F. Bukaty / AP

UMaine awarded $2.6M for research that could lead to more resilient bridges

Robert F. Bukaty / AP

Composites AM research targets wind

Robert F. Bukaty / AP

UMaine awarded $2.8 million to accelerate wind blade development through additive manufacturing

Orono, Maine — The University of Maine Advanced Structures and Composites Center has been awarded $2.8 million from the U.S. Department of Energy Office of Energy Efficiency and Renewable Energy to develop a rapid, low-cost additive manufacturing — 3D printing — solution for fabricating large, segmented wind blade molds. In addition, the UMaine Composites Center […]

Article by Bhandari and Lopez-Anido about research work in 3D printing published in the journal “Materials”

An article by PhD student Sunil Bhandari, titled Discrete-Event Simulation Thermal Model for Extrusion-Based Additive Manufacturing of PLA and ABS, has been published in a special issue “Additive Manufacturing Methods and Modeling Approaches” from the journal “Materials”. The article, which was co-authored by Dr Roberto A. Lopez-Anido, acts as a chapter in Bhandari’s dissertation. The […]